Starter Vape Kit accessories and spares for online stores
We ship starter vape kits to distributors, chain buyers and independent shops. What follows is the material we normally cover in a first conversation: what we hold in stock, how we test it, how it ships, and what happens when a carton arrives damaged.
Published 24 November 2025 · VapeWholesaleHub · Reading time 8 min
Paperwork, labelling and market rules
A starter vape kit programme only works when three numbers agree: your shelf price, your reorder cycle and your defect tolerance. Change one and the plan moves. We build assortments around those three and we say so up front rather than after the invoice.
If you sell into a market that requires child-resistant packaging, say so at quotation stage. Retrofitting a CR closure onto a finished bottle design usually means a new mould and a four week delay.
Artwork approval is a two stage process: a digital proof for text and layout, then a physical dummy for colour and finish. Skipping the dummy is the single most common cause of a reprint.
Turning shelf space into repeat visits
Counter space is finite. Three well-chosen SKUs outsell nine crowded ones, and the empty space signals a curated range rather than a clearance table.
Photography matters for online listings. Shoot on a neutral background with the device at a slight angle, show the pack alongside the unit, and keep the same framing across the range so the grid reads as a family.
What we test before a carton is sealed
A 0.5 percent defect rate sounds excellent until it lands on a 600 unit order and you are handling three returns in a week. We quote realistic rates per category and we credit in advance for the known failure modes.
Cosmetic grading is written down, not argued about. Minor scuffs inside the tolerance band are accepted; anything that would make a customer put the unit back on the shelf is rejected. Your staff should never have to explain a finish defect to a paying customer.
- Reference sample retained from every batch
- Mixed SKU cartons to spread first-order risk
- Specification locked in writing before production starts
- Document pack prepared per destination market
- Cartons drop-tested and pallet-counted for clean freight
- Artwork proof plus physical dummy for custom packaging
Reading a quotation properly
Freight is quoted separately and honestly. Bundling it into the unit price looks tidy and hides the one line that changes most often between shipments.
The cheapest way to lower your cost per unit is usually to remove a SKU, not to negotiate a discount. Fewer lines means larger runs, fewer changeovers and a better price at the same quality.
Specification summary
| Battery | 350 mAh |
| Pod capacity | 2.5 ml |
| Coil resistance | 1.0 ohm |
| Included | Device, pod, cable |
| Charging | USB-C 5V/1A |
| Packaging | Blister pack |
| Minimum order | 100 units per SKU, mixed cartons allowed |
| Lead time | 18 working days after artwork approval |
None of this is complicated. It is just written down, which is more than most buyers get before they wire a deposit.
Frequently asked
What happens if part of the order is defective?
Report within seven days with photos and the batch code. Confirmed defects are replaced or credited on the next shipment. The failure is logged by mode and batch, and reviewed monthly with the factory.
Can we order samples before committing?
Yes. Sample orders are shipped by air express and the cost is credited against your first production order above 500 units. We would rather you handle the sample than approve a specification from a photograph.
What is the minimum order for starter vape kit?
Standard configurations start at 500 units per SKU, with mixed SKUs allowed inside the same carton. Custom colours, custom packaging or a private label run usually start at 1000 units because of setup time on the line.
Related reading
Need a quotation on starter vape kits?
Send destination market, target price and quantity. Same-day reply on working days.
Tel / WeChat / WhatsApp +86 13711127975 · vape@0099933.xyz